Quote:
Originally Posted by Climaxxx
Hi Mate
Are you still on here???
|
Yer mate just your saw your PM
Il write back you here, best i can to help
Quote:
Originally Posted by Climaxxx
Hi Mate
I have 3.73 diff gears put in. Instant whine i thought was from gears but i think it's the trans, now after trans stuffed the bearings and a rebuild. A speedo corrector was installed at the ECU. The whine is still there with correct speed showing and the torque converter is still not locking up. It keeps hunting like it did before.I would og thought the trans people would of callibtated the car etc. Can you please help???
Thanks
Shane
|
Sorry for the delay
Sold the au so hard to get ya pics
Il explain best i can
Post photos here, and il show you how to do it
You need post photos here of the
3 wires running to transducer under car
inside engine bay, passenger side firewall where all the wires run through bung
Behind the glovebox
Behind the passenger side kickpanel
ECU
ECU plug
You will need to run a wire from the transducer
Under the car, passenger side of the gearbox,
Look for the 3 wires running up to the top, back of the box
You will need to find the white wire here, just strip a little plastic off, (do not cut it, no need ) too expose some copper
grab 4 metres of some 12 or 14 gauge wire and solder on
Run that wire, up into the firewall on the passenger side, you see a black bung on the firewall with a heap of wires going into it, thread that wire in with the others,
go into the car, remove the glovebox and you will see all those wires and your new wire coming through the bung
remove the kick panel on the passenger side to expose the
ECU,
Drill out the rivett and remove
ecu out enough to unplug, there is a screw on top on the plug that holds it to the
ecu, so unscrew it first
Grab the
ecu plug and look for pin 58, loosen up that wire,( its a white wire ), loosen it from the bundle and cut it 100mm to 200mm back from plug,
Join your new wire from transducer in this pin 58 wire on the plug, so now you have a direct line from transducer straight to pin 58
Tape and cap off the other end of the white wire you cut, it comes from elsewhere, and no longer required
Now look for pin 71, its a red wire
Strip back a bit of plastic and solder on 1 side of 1k ohm resistor to it,
Then on the other end of the resistor, solder than on to you pin 58 wire , preferably where you just did that new join
Hope my drawing helps
If not post pics and il help from the pics