Hi all
The Tickford AU2 200KW is up to its old tricks again
Drinking the fuel, stinky rich exhaust small loss of power hunting at idle.
Cleaned the
MAF
Its pulling 15" of vacuum at my altitude (1000m)
I've done a you tube clip of the scan readings
https://youtu.be/JaYz8f5UuNQ
Can someone who has experience with these AU injected Windsor's have a look and give me an opinion
I've noticed the 02s seem to be uneven, they have done 2000k only
Took them out they were a bit sooty as expected
When the
ECU is in open loop on cold starting the short term fuel trims start at about 18% rich and come down to about 3% till the
ECU goes into open then they head straight up to 40% rich
Can someone tell me if the
MAF,idle control,temp etc. are all in spec
last time it did this I replaced both o2s and it 95% fixed it
They are VDO brand,surely they couldn't be gone again with 2000k on them.
I also capped all vacuum ports to no effect
Would a bad cam sensor cause this,Ive tried disconnecting it to no effect
All help would be appreciated
Bret.