|
|
|
|
|
19-11-2011, 12:49 PM
|
#1 | ||
|
Sykmat
Join Date: Nov 2005
Location: Brisbane
Posts: 156
|
I am installing an aftermarket head unit into my LT Focus. I got everything ready then realised that I need special tools to remove the factory unit, the flat thin ones not the round wire like ones. Does anyone know where I can get a set in Brisbane? I have seen them on EBAY but that will take a month to arrive. IS there any other way to get the head unit out with out them?
Regards Matt. |
||
|
|
|
19-11-2011, 02:15 PM
|
#2 | ||
|
Regular Member
Join Date: Nov 2010
Location: Victoria
Posts: 435
|
Check out your dealers parts/service dept, they could have them or be able to get one in quicker than a month, only catch is you'll be paying more.
__________________
2010 LV Focus LX Titanium Grey - K&N Apollo CAI - 2" Cat-back Exhaust -18" Black with machined front RS rims - DRL/Halo Headlights - Eibach prokit springs - Front Strut Brace - Black XR5 Spoiler Plans: Whiteline Rear Sway bar |
||
|
|
|
|
19-11-2011, 02:20 PM
|
#3 | ||
|
Sykmat
Join Date: Nov 2005
Location: Brisbane
Posts: 156
|
I tried all that they only have the wire type. I have bee nable to successfully manufacture some out of some old file folders with the metal strip at the top, Worked a treat.
|
||
|
|
|
|
19-11-2011, 03:24 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Mar 2005
Location: Sausage Singlet NSW
Posts: 3,301
|
What about asking a local stereo install place if they can release the original unit from the dash for you, then order a set of the tools off eBay to have on hand in case you need to pull it out again. Obviously you will need to check that everything is functioning properly on the new unit before reinstalling it in the dash
|
||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Stereo Removal LT Focus
Linear Mode
