Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 28-05-2022, 12:20 PM   #1
auIILTD
5.6L x 2 pilot
Donating Member2
 
auIILTD's Avatar
 
Join Date: Dec 2009
Location: Canbra
Posts: 14,895
Valued Contributor: For members whose non technical contributions are worthy of recognition. - Issue reason: For the effort put into the Australia day cruise to Albury Tech Writer: Recognition for the technical writers of AFF - Issue reason: AU Tech article. 
Default Intech 6 No Spark

Good morning all.

I am currently having an issue with my AUII Forte. A couple of months back the car would not start for my step son. At the time it was throwing DTCs for primary fuel pump failure (P0230) and a P1358, which states "Electronic Distributorless Ignition System (EDIS) Central Processing Unit (CPU) failure. Reported if the EDIS CPU within the PCM fails. The powertrain CPU is not receiving any signal from the Ignition Diagnostic Monitor (IDM)". So being the easiest, I replaced the fuel pump and cleared the DTCs. Of course that did not fix the car, so I bought a new coil pack and leads. Bingo, car started and no more DTCs.

The car was fine for a few weeks, and then again one morning it would not start. It was throwing the same P1358 DTC. During diagnosis, I was under the car and checked the loom to coil pack connection. It seemed fine, but I disconnected it to look at the pins, also seemed fine and reconnected it. Checking the car again it started again! By this stage, I had bought another coil pack, on the off chance the one I had bought was faulty.

Fast forward another few weeks and the car then again would not start. Checked the connection again and even replaced the coil pack with the new one to no avail. Again it is throwing the same P1358 trouble code. That is how the car sits to this point in time.

I do not believe it to be fuse related as they either work or do not. I do not believe it is the coil pack, the chances of buying two faulty new ones would be very low.

I do have some more diagnostics to run, but I was wondering if anyone has experienced anything similar on their 6 cyl Falcon? Any input appreciated.

Cheers
Stu
__________________
2002 AU II LTD

5.6L 342ci T3 Short, AFR165 heads, Comp XE270HR-12 Cam, Brembo 4/4s(355/330), T3 5 spokes, LC-1 wideband, Whiteline HD swaybars, TCE 3K Hi Stall, PWR Auto Trans Cooler, Koni shocks, King Low Springs, Hurricane headers, 100 cpsi cats, Twin 2.5" exhaust.

Quarter Mile: 13.73 @ 105.86mph


Runner Up NA/DA to BF Fairlane/LTD Geelong AFD 2024

2002 XR8 pursuit 250

Custom twin 2.5" exhaust w Herrod modifed extractors, Tuned with Moates QH
auIILTD is offline   Reply With Quote Multi-Quote with this Post
 


Forum Jump


All times are GMT +11. The time now is 03:41 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL