|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
25-05-2009, 06:44 AM
|
#1 | ||
|
Starter Motor
Join Date: May 2009
Posts: 1
|
fitting another distrubtor, crank pulley to tdc #1 cyl at top of stroke
does rotor point to # 1 lead on the dizzy cap !!!! , as it seems to prefer not to any help please.  : |
||
|
|
|
29-05-2009, 04:09 PM
|
#2 | ||
|
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
yes the rotor should point to the number one spark plug lead
you may only be out one tooth of the dissy cog fit the dissy so the rotor is pointing to the number one plug lead
__________________
My car goes Brumm Brumm |
||
|
|
|
|
30-05-2009, 12:01 AM
|
#3 | ||
|
growing up is optional
Join Date: Feb 2006
Location: Gawler area SA
Posts: 3,303
|
Dont forget that number 1 will be at the top twice for each cycle. My guess is you are 180 degrees out. To get it right either whack your thumb over number 1 plug hole and flick the key to feel compression then line up your crank marks, or take the rocker cover off and check if number 1 inlet and exhaust rockers have clearance. If you are 180 degrees out, number 4 rockers will have clearance.
IIRC the dissy will only fit onto the cam in one position anyway (offset drive 'plate') so you cannot put it in wrong. Whack it in and see if it starts. |
||
|
|
|
kc laser 1.6
Linear Mode
