[cobrin]

Well Bundybear75, I know what you experienced.



Today I helped an old neighbour from way back replace his timing belt on his 2010 MB (even though it has the MC engine and refreshed front end updates). It went without a hitch. I enjoyed doing it and now I feel I've gotten my moneys worth out of the timing setting tools. Neighboors/family friend are happy and that's all that matters. I didn't forget how much of a pain in the **** it was to get the startermotor out of the way but that at least went okay this time.j<shocked>



That and the flywheel pin fitted nicely (unlike my own engine) but the ring-gear tool I couldn't use because the starter motor has the threads in it and with that out the way I had no nuts to bolt the tool to the block, so I simply left it out and pinned it only along with the pinned cam sprocket. Verified my work by hand turning it over (4 crank revolutions for one complete combustion cycle). Locked it down again and torqued the crank pulley bolt and then filled it with coolant and started her up....BEAUTIFUL!!!



There's another Mondeo back on the roads for another 240k kms/ 10yrs if things go right.