Quote:
Originally Posted by minorthreat
I didn't mean any offence, if so I apologise. I wasn't referring to concourse or factory correct in that sense.
Just was wondering if that maybe the reason the rack mounts don't sit flat under the chassis rails. If the crossmember was bowed down.
If you can imagine the lines are the chassis rails and the arrow is the crossmember /v\ that would explain why the outer edges are not sitting flat.
Or is it just the RRS mounts arn't a perfect 90 bend
Cheers
|
You know I was joking right?.. yeah the brackets are good, I did use clamps to pull them tights against the bottom of the chassis rail & it's clear that it's my crossmember that's had a smack & will need to be repaired.
The only reason I haven't drilled & bolted the additional two holes up on the brackets is I'm deciding if bolting is the way to go or if I weld them on instead.