|
|
|
|
|
11-03-2022, 01:11 AM
|
#1 | ||
|
Starter Motor
Join Date: May 2020
Location: Perth
Posts: 14
|
Howdy, I have installed a LED lightbar behind the grille on my MD, but I need to get the switch wire from the engine bay into the interior to mount pon the dash (or under somewhere...
Does anyone know of a good place to get the wires through the firewall? |
||
|
|
|
11-03-2022, 04:17 AM
|
#2 | ||
|
Regular Member
Join Date: Feb 2016
Location: Goulburn NSW
Posts: 316
|
I ended up leaving the switch for mine under the bonnet, and just using a relay and high beam active to turn my driving lights on and off.
__________________
2012 MC Mondeo LX TDCi Wagon - Highway Hack 392K km and counting - Now gone 😢 2008 Peugeot 308 HDi - Highway Hack II 2008 Citroen C4 HDi - Highway Hack III 2010 Peugeot 308 HDi SW - Shaggin Wagon II 2016 VDJ200R Landcruiser GX Wagon - TTD V8 Power  !2017 Toyota RAV4 GX Wagon - Shopping trolley - Gone 2022 Volvo XC40 T4 Inscription - Shopping trolley II 2002 BMW R1150GS |
||
|
|
|
|
11-03-2022, 08:22 AM
|
#3 | ||
|
FF.Com.Au Hardcore
Join Date: Jul 2012
Posts: 3,852
|
There should be a wiring rubber grommet somewhere on the firewall that you can feed the wiring through bedside the existing wiring.If not drill a 5mm hole and put a dob of silastic on the wire to seal it
|
||
|
|
|
31-03-2022, 06:45 PM
|
#4 | |||
|
Starter Motor
Join Date: Apr 2010
Posts: 16
|
Quote:
 (If you are likely to tinker in the future, run some 5 or 7 core trailer wire - that way you only have to do it once and you have a few spare circuits for gauges and accessories) |
|||
|
|
|
| This user likes this post: |
|
01-04-2022, 05:35 PM
|
#6 | ||
|
Starter Motor
Join Date: Apr 2010
Posts: 16
|
Very neat!
Personally, as this is about as close as I'll ever get to an Aston Martin, I feel like 'round' is calling me:  (photoshop) |
||
|
|
|
| This user likes this post: |
Wiring from enginbe bay to cabin
Re: Wiring from enginbe bay to cabin
Linear Mode
