what to use to stick tickford badges on with?

[tim_pato]

well i've put the hp motor, lsd,17"s, letherseats momo wheel and blue cluster in my ded gas ute figure i'd put the badges under the side indicators. question is what to stick them on with that wont fall off, but still be able to take them off in 1 piece when, in the distant future i paint it.

[my67xr]

use some 3M double sided tape, 20mm wide.
otherwise Bunnings sell some good outdoor Scotch brand double sided tape too

[tim_pato]

that was my first thought, has ot been tr'd nd tested?

[my67xr]

that what ford uses, and most crash shops too

here is the pack bunnings sells, basically the same as the automotive stuff.
http://www.bing.com/images/search?q=...73E9&first=172

[tim_pato]

ok thanks, on tomorrows to do list.

[phr33k]

when you go to bunnings, get the scotch '4010' tape, it is a clear double sided tape, they say is 'permanent' it is by far the best double sided tape i've used for badges when i was panelbeating should be about 6 dollars for a 2 meter roll

http://www.masters.com.au/product/90...e-25-4mmx1-51m

check that... 9 dollars for 1.5m

[my67xr]

Originally Posted by phr33k

when you go to bunnings, get the scotch '4010' tape, it is a clear double sided tape, they say is 'permanent' it is by far the best double sided tape i've used for badges when i was panelbeating should be about 6 dollars for a 2 meter roll

that's the same as what i posted above?

[tim_pato]

Originally Posted by my67xr

that's the same as what i posted above?

yes
but easier for a dolt like me to follow!

[phr33k]

Originally Posted by my67xr

that's the same as what i posted above?

ah, it could be, did check out your link, but it didn't show much for me, didn't load properly or something, but it shows great minds think alike

[T4ME]

Liquid nails?

[tim_pato]

ended up getting norton permanant outdoor as that was all bunnings had.

[peterljohnson55]

sTick-Ford glue, of course.